The conventional modal testing, hereafter referred as Displacement Modal Testing (DMT) is based on measurement of displacement, velocity or acceleration as well as excitation force. An enormous literature regards the DMT, on the contrary, a few papers address modal testing based on strain gauges or strain sensor, hereafter referred as Strain Modal Testing (SMT). The main reason of this scenario is due to practical problems in the use of strain gauges as calibration procedure, ground loop, sensitivity not adequate at high frequency, bonding quality. In this work, a novel piezoelectric strain sensor is used for SMT. It is demonstrated in the present work that this sensor overcomes the practical drawbacks related to the use of strain gauges. Thus, SMT based on piezoelectric strain sensors can be a valid alternative to DMT which is usually based on accelerometers. Comparisons between the modal testing results concerning brackets with different constraint conditions using both accelerometers and strain sensors are given in terms of modal parameters, highlighting their pros and cons.

ON THE COMPARISON BETWEEN DISPLACEMENT MODAL TESTING AND STRAIN MODAL TESTING

MUCCHI, Emiliano;DALPIAZ, Giorgio
2015

Abstract

The conventional modal testing, hereafter referred as Displacement Modal Testing (DMT) is based on measurement of displacement, velocity or acceleration as well as excitation force. An enormous literature regards the DMT, on the contrary, a few papers address modal testing based on strain gauges or strain sensor, hereafter referred as Strain Modal Testing (SMT). The main reason of this scenario is due to practical problems in the use of strain gauges as calibration procedure, ground loop, sensitivity not adequate at high frequency, bonding quality. In this work, a novel piezoelectric strain sensor is used for SMT. It is demonstrated in the present work that this sensor overcomes the practical drawbacks related to the use of strain gauges. Thus, SMT based on piezoelectric strain sensors can be a valid alternative to DMT which is usually based on accelerometers. Comparisons between the modal testing results concerning brackets with different constraint conditions using both accelerometers and strain sensors are given in terms of modal parameters, highlighting their pros and cons.
File in questo prodotto:
Non ci sono file associati a questo prodotto.

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11392/2338674
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 0
  • ???jsp.display-item.citation.isi??? ND
social impact